National Instruments E Series - Page 123

 National Instruments Corporation I -1 DAQCard E Series User Manual
Index
Numbers
+5 V signal
description, 4-3
power connections, 4-22
A
ACH<0..15> signal
analog input connections, 4-10
DAQCard-AI-16E-4 (table), 4-5
DAQCard-AI-16XE-50 (table), 4-8
description, 4-3
AIGATE signal, 4-34 to 4-35
AIGND signal
analog input connections, 4-10 to 4-11
DAQCard-AI-16E-4 (table), 4-5
DAQCard-AI-16XE-50 (table), 4-8
description, 4-3
differential connections for floating
signal sources, 4-16 to 4-17
AISENSE signal
analog input connections, 4-10
DAQCard-AI-16E-4 (table), 4-5
DAQCard-AI-16XE-50 (table), 4-8
description, 4-3
amplifier characteristic specifications
DAQCard-AI-16E-4, A-3
DAQCard-AI-16XE-50, A-9
analog input, 3-2 to 3-8
dither, 3-6 to 3-7
input mode, 3-2 to 3-3
input polarity and range, 3-3 to 3-5
DAQCard-AI-16E-4, 3-3 to 3-4
DAQCard-AI-16XE-50, 3-4 to 3-5
multichannel scanning considerations,
3-7 to 3-8
power-management modes (table), E-2
questions about, D-3
selection considerations, 3-6 to 3-7
signal connections, 4-10 to 4-11
analog input specifications
DAQCard-AI-16E-4, A-1 to A-4
amplifier characteristics, A-3
dynamic characteristics, A-3 to A-4
input characteristics, A-1 to A-2
stability, A-4
transfer characteristics, A-3
DAQCard-AI-16XE-50, A-8 to A-10
amplifier characteristics, A-9
dynamic characteristics, A-9 to A-10
input characteristics, A-8
stability, A-10
transfer characteristics, A-9
analog trigger, 3-9 to 3-12
above-high-level triggering mode
(figure), 3-10
below-low-level triggering mode
(figure), 3-10
block diagram, 3-9
high-hysteresis triggering mode, 3-11
inside-region triggering mode
(figure), 3-11
low-hysteresis triggering mode, 3-12
B
bipolar input
DAQCard-AI-16E-4, 3-3
DAQCard-AI-16XE-50, 3-4 to 3-5
mixing bipolar and unipolar channels
(note), 3-5
This document was created with FrameMaker 4.0.4