National Instruments E Series - Page 125

Index
 National Instruments Corporation I -3 DAQCard E Series User Manual
ground-referenced signal sources, 4-15
illustration, 4-15
nonreferenced or floating signal sources,
4-16 to 4-17
illustration, 4-16
recommended configuration
(figure), 4-13
single-ended connections, 4-18
floating signal sources (RSE), 4-19
grounded signal sources (NRSE),
4-19 to 4-20
when to use, 4-14
differential input mode, questions about, D-3
digital I/O
operation, 3-12
power-management modes (table), E-2
questions about, D-3 to D-5
signal connections, 4-21 to 4-22
specifications
DAQCard-AI-16E-4, A-5
DAQCard-AI-16XE-50, A-11
DIO<0..7> signal
DAQCard-AI-16E-4 (table), 4-6
DAQCard-AI-16XE-50 (table), 4-8
description, 4-3
digital I/O connections, 4-21 to 4-22
dither
enabling, 3-6 to 3-7
signal acquisition effects (figure), 3-7
documentation
conventions used in manual, xii-xiii
National Instruments documentation,
xiii-xiv
organization of manual, xi-xii
related documentation, xiv
dynamic characteristic specifications
DAQCard-AI-16E-4, A-3 to A-4
DAQCard-AI-16XE-50, A-10
E
EEPROM storage of calibration constants, 5-1
electronic support services, F-1 to F-2
e-mail support, F-2
environment specifications
DAQCard-AI-16E-4, A-7
DAQCard-AI-16XE-50, A-12
environmental noise, avoiding, 4-44
equipment, optional, 1-5 to 1-6
EXTSTROBE* signal
DAQCard-AI-16E-4 (table), 4-6
DAQCard-AI-16XE-50 (table), 4-8
description, 4-3
timing connections, 4-27
illustration, 4-27
F
fax and telephone support, F-2
FaxBack support, F-2
field wiring considerations, 4-44
floating signal sources
description, 4-12
differential connections, 4-16 to 4-17
recommended configuration
(figure), 4-13
single-ended connections (RSE
configuration), 4-19
FREQ_OUT signal
DAQCard-AI-16E-4 (table), 4-7
DAQCard-AI-16XE-50 (table), 4-9
description, 4-5
general-purpose timing connections, 4-43
frequently asked questions. See questions and
answers.
FTP support, F-1