Index
National Instruments Corporation I -5 DAQCard E Series User Manual
differential connections
DIFF input configuration, 4-14
floating signal sources, 4-16 to 4-17
ground-referenced signal
sources, 4-15
nonreferenced signal sources,
4-16 to 4-17
recommended configuration
(figure), 4-13
single-ended connections, 4-18 to 4-20
floating signal sources (RSE
configuration), 4-19
grounded signal sources (NRSE
configuration), 4-19 to 4-20
input polarity and range, 3-3 to 3-5
DAQCard-AI-16E-4
actual range and measurement
precision (table), 3-4
unipolar and bipolar, 3-3 to 3-4
DAQCard-AI-16XE-50
actual range and measurement
precision (table), 3-5
unipolar and bipolar, 3-3 to 3-5
dither, 3-6 to 3-7
mixing bipolar and unipolar channels
(note), 3-5
selection considerations, 3-6 to 3-7
installation
hardware, 2-1
questions about, D-2
software, 2-2 to 2-3
typical configuration (figure), 2-2
unpacking DAQCard E Series, 1-6
I/O connectors, 4-1 to 4-9
cable connectors for DAQCard E Series,
1-6
exceeding maximum ratings
(warning), 4-1
I/O signal summary (table)
DAQCard-AI-16E-4, 4-5 to 4-7
DAQCard-AI-16XE-50, 4-8 to 4-9
pin assignments (figure)
50-pin AI connector, B-3
68-pin AI connector, B-2
DAQCard-AI-16E-4 and
DAQCard-AI-16XE-50
(figure), 4-2
signal descriptions (table), 4-3 to 4-5
L
LabVIEW and LabWindows/CVI application
software, 1-2 to 1-3
M
manual.
See documentation
.
memory conflict, C-2, C-4
multichannel scanning, 3-7 to 3-8
N
NI-DAQ driver software, 1-3 to 1-4
power-down utility, A-12
noise, avoiding, 4-44
NRSE (nonreferenced single-ended input)
description (table), 3-3
differential connections, 4-16 to 4-17
recommended configuration
(figure), 4-13
single-ended connections (NRSE
configuration), 4-19 to 4-20
O
optional equipment, 1-5 to 1-6
P
PC (PCMCIA) Card questions and answers,
C-1 to C-4
configuration, C-1
operation, C-2
resource conflicts, C-4
resources, C-2 to C-4
To Next Page
Loading...
