National Instruments GPIB-PC - Page 106

Section Four A BASICA/QuickBASIC GPIB-PC Function Calls
©National Instruments Corp. 4A-31 GPIB-PC User Manual
Device Example:
1. Send the END message with the last byte of all subsequent
writes to the device PLOTTER%.
100 V% = 1 ' Enable sending of EOI.
110 CALL IBEOT (PLOTTER%,V%)
120 REM It is assumed that WRT$ contains
130 REM the data to be written to the GPIB.
140 CALL IBWRT (PLOTTER%,WRT$)
Board Examples:
1. Stop sending END with the last byte for calls directed to the
interface board BRD0%.
100 V% = 0 ' Disable sending of EOI.
110 CALL IBEOT (BRD0%,V%)
:
:
2. Send the END message with the last byte of all subsequent
write operations directed to the interface board BRD0%.
100 V% = 1 ' Enable sending of EOI.
110 CALL IBEOT (BRD0%,V%)
120 REM It is assumed that WRT$ contains
130 REM the data to be written and all
140 REM Listeners have been addressed.
150 CALL IBWRT (BRD0%,WRT$)