National Instruments GPIB-PC - Table 2.1 - Timeout Settings

Section Two Installation and Configuration
©National Instruments Corp. 2-13 GPIB-PC User Manual
This field is set to a code mnemonic which specifies the time limit as
follows:
Table 2.1 - Timeout Settings
Code Actual Value Minimum Timeout
TNONE 0 disabled
T10µsec 1 10 µsec
T30µsec 2 30 µsec
T100µsec 3 100 µsec
T300µsec 4 300 µsec
T1msec 5 1 msec
T3msec 6 3 msec
T10msec 7 10 msec
T30msec 8 30 msec
T100msec 9 100 msec
T300 10 300 msec
T1sec 11 1 sec
T3sec 12 3 sec
T10sec 13 10 sec
T30sec 14 30 sec
T100sec 15 100 sec
T300sec 16 300 sec
T1000sec 17 1000 sec
NOTE: If you select TNONE, no limit will be in effect.