IBIC Section Five
GPIB-PC User Manual 5-2 ©National Instruments Corp.
Running IBIC
The IBIC program, IBIC.EXE, is an executable file that was copied
from the distribution diskette to a subdirectory called GPIB-PC when
you ran IBSTART at installation.
To run IBIC, change directory to C:\GPIB-PC and enter:
C:\GPIB-PC>
ibic
National Instruments
Interface Bus Interactive Control Program (IBIC)
Copyright (c) 1984 National Instru ments, Inc.
All Rights Reserved
Type "help" for help.
Use IBFIND to initially open a boa rd or device.
Use SET to select an already opene d board or device.
Messages will appear on the screen that give you information about the
HELP, IBFIND, and SET commands.
The first input prompt to IBIC is a colon (:).
NOTE: In using IBIC, the four most important functions are the HELP,
IBFIND, IBWRT, and IBRD commands.
To Next Page
Loading...
