Section Five IBIC
©National Instruments Corp. 5-9 GPIB-PC User Manual
Table 5.1 - Syntax of GPIB Functions in IBIC (continued)
Request service ibrsv v d3
Change seconday address ibsad v db 3
Send interface clear ibsic b3
Set/clear remote enable line ibsre [v] b 2,3
Abort asynchronous operation ibstop db
Change/disable time limit ibtmo v db 3
Configure applications monitor ibtrap
mask v db 3,8
Trigger selected device ibtrg d
Wait for selected event ibwait
[mask] db 2,8
Write data ibwrt
stringd b4
Write data asynchronously ibwrta
string db 4
Write data to file ibwrtf
flname db 7
NOTES
1. bname is the symbolic name of the new board, e.g., ibbna
gpib1.
2. Values enclosed in square brackets ([]) are optional. The
default value is 0 for ibwait and 1 for all other functions.
3. v is a hex, octal, or decimal integer. Hex numbers must be
preceded by zero and x (e.g., 0xD). Octal numbers must be
preceded by zero only (e.g., 015). Other numbers are assumed
to be decimal.
4. string consists of a list of ASCII characters, octal or hex
bytes, or special symbols. The entire sequence of characters
must be enclosed in quotes. An octal byte consists of a
backslash character followed by the octal value. For example,
octal 40 would be represented by \40. A hex byte consists of a
backslash character and a character x followed by the hex
value. For example, hex 40 would be represented by \x40.
The two special symbols are \r for a carriage return character
and \n for a linefeed character. These symbols provide a more
convenient method for inserting the carriage return and linefeed
To Next Page
Loading...
