Connecting to a Spring-Terminal Connector
What to Use
• NI 9375 spring-terminal connector
• 0.08 mm
2
to 1.0 mm
2
(28 AWG to 18 AWG) copper
conductor wire with 7 mm (0.28 in.) of insulation stripped
from the end
• Flathead screwdriver with a 2.3 mm x 1.0 mm (0.09 in. x
0.04 in.) blade, included with the NI 9375
What to Do
Complete the following steps to connect wires to the spring-
terminal connector.
NI 9375 Getting Started Guide | © National Instruments | 15
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
