National Instruments PCI-8430 - Page 80

UsingtheCFGRESETSwitchatPower-On
Intheeventyouforgetthenetworkconfigurationthataparticularserial
ENETinterfaceisusing,youcanresettheunittoitsdefaultnetwork
characteristics.BypressingandholdingtheCFGRESETswitchwhile
youpowerontheserialENETinterface,thenetworkparametersrevertto
thedefaultsettingsasdefinedonthebaseplatelabel.
Youmustpressandholdtheswitchforapproximatelythreesecondsuntil
thePWR/RDYLEDbecomessolidred.Ifyoureleasetheswitchpriorto
threeseconds,nochangeoccurstothenetworkconfiguration,andthe
serialENETinterfacecontinuestobootnormally.
ThePWR/RDYLEDgoesthroughthefollowingchangesduringthese
threeseconds:
1. TheLEDbeginsslowlyalternatingbetweenredandyellow.
2. Thealternatingpatternincreasesintempo.
3. Atthreeseconds,thePWR/RDYLEDbecomessteadyred.This
indicatesthenetworkconfigurationwillbesettothefactory
defaultsettings.
4. WhenyoureleasetheCFGRESETswitch,theboxcontinuesto
bootasnormal,andthePWR/RDYLEDindicatestheboot
processasdescribedinENETLEDDescriptions.