What If I Can’t See The Video?
This problem usually results from having the video card output set past the monitor
limits. To resolve the problem, start Windows in Safe Mode by rebooting the
controller. As Windows begins to restart, hold down <F8>. You now should be able to
reset the video driver to lower settings. Try setting the resolution to 800 × 600 and
the refresh rate to 60 Hz. Once you restart, you can raise these values again, using
the test option in Windows. You can access these settings by clicking Adjust screen
resolution in the Appearance and Personalization category of the Control
Panel. You also can try a dierent monitor, preferably a newer and larger one.
My system boots fine as long as a particular module is not in my
chassis. How do I boot the chassis with the module installed?
The most common cause of this problem is a damaged module. Try the module in a
dierent chassis or with a dierent controller. Also, remove any external cables or
terminal blocks connected to the system. If the module does not work in these
cases, it is likely damaged. Contact the module manufacturer for further
troubleshooting.
My chassis or controller does not appear in MAX. How do I use MAX
to identify and configure my PXI system?
If you are using MAX to configure your PXI system, you must install the PXI Platform
Services soware on your controller to identify NI PXI and PXI Express chassis and
modules in MAX. You can install PXI Platform Services from the soware CD included
with your controller or from
ni.com/downloads.
My CMOS is corrupted. How do I set it back to default?
There are two methods that you can use to reset the CMOS.
1.
First Method
1.
Enter the BIOS setup program as described in the Accessing BIOS
Setup Utility section of the NI PXIe-8840 Quad-Core User Manual for
more information.
ni.com
22
PXIe-8840 Quad Core
To Next Page
Loading...
Need help?
General
