National Instruments PXIe-8840 Manual

This document includes instructions for installing and configuring your
NI PXIe-8840 Quad-Core PXI Express controller module.
For complete configuration information (including BIOS configuration, ExpressCard
installation, hard drive recovery, memory upgrade, and OS installation), full
specifications, and I/O information, refer to the NI PXIe-8840 Quad-Core User
Manual.
Getting Started
This section includes instructions for unpacking and installing your
NI PXIe-8840 Quad-Core controller, including setting up your controller to run
LabVIEW Real-Time. It also describes the controller's front panel connectors.
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits
for electromagnetic compatibility (EMC) stated in the product specifications. These
requirements and limits provide reasonable protection against harmful interference
when the product is operated in the intended operational electromagnetic
environment.
This product is intended for use in industrial locations. However, harmful
interference may occur in some installations, when the product is connected to a
peripheral device or test object, or if the product is used in residential or
commercial areas. To minimize interference with radio and television reception and
prevent unacceptable performance degradation, install and use this product in strict
accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved
by National Instruments could void your authority to operate it under your local
regulatory rules.
Caution To ensure the specified EMC performance, operate this product
only with shielded cables and accessories.
© National Instruments
3
PXIe-8840 Quad Core

National Instruments PXIe-8840 Specifications

General

Brand	National Instruments
Model	PXIe-8840
Category	Controller
Language	English