National Instruments PXIe-8840 Manual

1. Plug in your chassis before installing the NI PXIe-8840 Quad-Core. The power
cord grounds the chassis and protects it from electrical damage while you
install the module.
Caution In some National Instruments chassis, you must ensure
that the power LED is o. For more information about chassis power
behavior, refer to the user manual for the specific chassis.
Caution To protect both yourself and the chassis from electrical
hazards, leave the chassis o until you finish installing the
NI PXIe-8840 Quad-Core.
2.
Remove any panels blocking access to the system controller slot (Slot 1) in the
chassis.
3. Touch the metal part of the chassis case to discharge any static electricity that
might be on your clothes or body.
4.
Remove the protective plastic covers from the four bracket-retaining screws as
shown in the following figure.
Figure 1. Removing Protective Plastic Covers
1
1.
Protective Screw Cap (4x)
ni.com
6
PXIe-8840 Quad Core

National Instruments PXIe-8840 Specifications

General

Brand	National Instruments
Model	PXIe-8840
Category	Controller
Language	English