RMC-8356 Installation Guide | © National Instruments | 17
Environmental
Caution If installed in a closed or multi-unit rack assembly, the rack environment
operating ambient temperature may be greater than room ambient temperature.
Therefore, install the equipment in an environment compatible with the maximum
ambient temperature (Tma) the manufacturer specifies.
Operating temperature ...................................... 10 to 35 °C
(Tested in accordance with IEC 60068-2-1.)
Storage temperature ......................................... -40 to 60 °C
(Tested in accordance with IEC 60068-2-1 and
IEC 60068-2-2.)
Relative humidity (Tested in accordance with IEC 60068-2-56)
Operating .................................................. 8 to 90% noncondensing
Nonoperational (storage) .......................... 5 to 95% noncondensing
Operating location ............................................ Indoor use only
Maximum altitude............................................. 2,000 m
Installation Category......................................... II
Pollution Degree ............................................... 2
Acoustic Emissions
Sound pressure level (at front bystander position)
Minimum .......................................................... 53.1 dBA
Maximum.......................................................... 61.4 dBA
Safety
This product is designed to meet the requirements of the following standards of safety for
information technology equipment:
• IEC 60950-1, EN 60950-1
• UL 60950-1, CSA 60950-1
Caution Overloading the circuits may damage supply wiring. Do not exceed the
ratings on the equipment nameplate when connecting equipment to the supply circuit.
Note For UL and other safety certifications, refer to the product label or the Online
Product Certification section.
To Next Page
Loading...
Need help?
General
