41
18. Before fully attaching the Shrouds, power up the machine to verify that
the Magnet Arm can move freely, and that the Brake Magnet and Flywheel
donottouchatthemaximumresistancelevel.
!
Machine is on. Current is active. There is risk of electrical
shock. Be sure to keep ngers clear of all pinch hazards when
you change the resistance level.
19. Installation is the reverse procedure.
PuttheLeftShroudinpositionrsttoalignthescrewsfortheRight
Shroud.Installthetopscrewsrst.BesurethetabsintheMotorizedLift
Cover snap into the Side Shrouds.
NOTICE: This step may require two people. Be sure not to crimp
any cables.
Note: Self-tapping screws attach the Shrouds to the Frame.
Installation does not require the use of the crank puller. Be sure the Crank
Arms are connected at 180° from each other.
20. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
After replacing the Brake Assembly, the resistance levels of the machine
may be different. The user should adjust their workout levels accordingly.
To Next Page
Loading...
Need help?
General
