80
13. Tie the end of the string out of the side of the Cable Mast to the upper
end of the replacement Remote Incline Cable. Hold the other end of the
string and carefully pull the new Remote Incline Cable through the Cable
Mast.
NOTICE: Do not crimp the cables.
14. Untie the string from the new Remote Incline Cable.
15. Reassembly is the reverse procedure.
NOTICE: Do not crimp the cables. Untie the string from the Lift
Motor Wire. Do not allow the cables to fall down into the
Console Mast.
Be sure the tabs in the Top Shroud snap into the Main
Assembly.
16. Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
To Next Page
Loading...
Need help?
General
