24
Step 13: Thread Cable Through Pulley Assemblies,
continued
d. From there, thread the cable all the way up
over the 6” pulley on the right side and back
down in front of the Weight Stack Pulley
Assembly (Figure 18).
e. Thread the cable under the Weight Stack
Pulley Assembly and up behind it.
f. Going up again, thread the cable over
the 6” pulley on the right side of the Tower
and under the 4 1/2” pulley on the Row
Attachment Assembly (Figure 19).
g. Attach the remaining washer, Cable Ball, and
Slotted Strap Fork.
Note: To align the Weight Stack Pulley, first
make sure that the tension nuts are loose
(assembly should rotate freely) and that all
other steps have been completed.
With the weight pin inserted (amount of
weight is unimportant; simply ensure there is
some weight), pull the cable handles until the
cable is just tight. This should rotate the
pulley to the correct orientation. Tighten the
tension nuts while the cable is tight.
13-3 Tighten the hardware on the Top Pulley
Assemblies.
13-4 Attach remaining accessories (carabineers,
handles).
Figure 18:
Figure 19:
ASSEMBLY GUIDE
To Next Page
Loading...
Need help?
General
