5
OPERATION
> Moving your bike
To move your bike, carefully lift the rear end of the bike by pushing
down on the front of the handlebars. Steer the bike to another loca-
tion. Be gentle while moving the unit as any sharp impact directly or
indirectly to the computer can affect computer operation. (Fig.8) To
move your recumbent, lift the back end of the unit and steer using
the stabilizer tube. (Fig.9)
IMPORTANT: Be careful when moving your bike as it is heavy and
awkward. If you do not feel comfortable moving the unit by yourself,
get help. The transport wheels are designed for indoor use only and
should not be used to move the unit over rough surfaces such as
concrete or asphalt.
> Leveling your bike
Your bike can be leveled to compensate for uneven surfaces. To
level the bike, raise or lower the two leveling bolts located on
the underside of the rear stabilizer by screwing them in or out as
needed. (Fig.10)
> Maintenance
Use a damp cloth to wipe your bike and computer free of sweat.
IMPORTANT: To avoid damaging the finish on your bike and com-
puter, never use a petroleum-based solvent when cleaning. Avoid
getting excessive moisture on the computer.
ADDITIONAL INFORMATION
> fig.8
> fig.9
> fig.10
To Next Page
Loading...
Need help?
General
