12
Recharging the Battery Back-Up
The Commercial Series U916 and R916 bikes are both self-powered (cordless) with a rechargeable battery back-up.
Typically, the bike can be operated without plugging in the battery charger. If, however, the console flickers during
operation or the console display does not light up while using the machine, then use the battery charger to recharge the
battery back-up.
The battery charger is supplied with the unit and plugs into a standard 115 volt, 15 amp outlet, or a 220 volt, 15 amp outlet.
(All major voltage plugs are available.) The plug-in for the battery charger is located
in the front of the machine at the base.
NOTE: If installing the optional LCD Monitor, refer to the NV915 installation manual at
this time.
Plug the wall pack battery charger into the connector and charge the battery for
approximately 24 hours and then recheck it. It is okay to use the machine while the
battery charger is connected.
When the bike is not connected to an external power source, the console will power
on as the user starts to pedal machine, and will stay lit for up to 60 seconds in pause
mode. The console will power off after 60 seconds of stopping exercise.
If the bike is connected to an external power source, the console will power on automatically and stay on until power is
disconnected.
Battery Disposal
When ordering new batteries, you will need to properly dispose of (recycle) your old lead-acid batteries. Most federal
and state regulations require lead-acid batteries to be recycled. Do not throw away old batteries. Lead is a toxic heavy
metal, hazardous to living organisms. Disposal instructions and a list of recycling centers are tabulated in the Appendix.
If you have questions, contact the Customer Service Department at 800-628-8458 (North America) or +41-26-460-77-77
(International office).
Battery charger plug-in
Maintenance
To Next Page
Loading...
Need help?
General
