Navien NaviLink User Manual

15
English
Configuring the connection setting mode for NFB
(residential) models
Adjusting this setting is required for single NFB (residential) units ONLY.
Do not adjust any of the following parameters for cascade systems.
To view and configure the external network connection, press the Back
button (
) and the Menu button ( ) simultaneously for 3 seconds,
and then select “5. External Connection”.
7
When you are done, press the Mode button to save the settings.
8
To exit the Special Parameter mode, press the Reset button twice.
Parameters must be set by a qualified professional with an extensive
understanding of the boiler system. Setting parameters improperly may
lead to property damage or injury.
Verify that the NaviLink connection setting mode is disabled (OFF) for
cascade systems.

Navien NaviLink Specifications

General

Brand	Navien
Model	NaviLink
Category	Remote Control
Language	English