36
is switched on, the APPCON 3000 charges only insufciently with
approx. 1 Watt. By the way, like all the others.
Light cable test
Test the light now to see if it works. If it doesn‘t light up at all or only
weakly, it may be because the ground connection of the old light
cable is reversed. In this case, swap the two connections of the old
light cable. However, you cannot break anything. Don‘t worry. Now
ride the bike for a short distance (5 meters are enough). The LED
of the APPCON 3000 should now ash blue.
You have now successfully completed the installation!
If there is a problem somewhere and you get grey hair, call our hot-
line in advance if possible: +49 (0) 2234-9494000 or +49 (0) 2234
20 38 911 or info@nc-17.de. Thank you
Important note
To prevent the ingress of water, the APPCON 3000 must never
be sprayed or submerged with a sharp jet of water (hose, high-
pressure cleaner). Always use the supplied carbon protective cover
for the APPCON 3000.
lighting system
The APPCON 3000 „harvests“ the energy of the hub dynamo and
thus charges its internal battery. However, the APPCON 3000 only
draws energy from the hub dynamo when the bicycle lighting is
switched off.
You switch on the energy management of the APPCON 3000 by
switching off the bicycle lighting. At night it is therefore not possible
or useful for the APPCON 3000 to harvest energy.
To Next Page
Loading...