Need help?Do you have a question about the NC SW6 and is the answer not in the manual?
General| Brand | NC |
|---|---|
| Model | SW6 |
| Category | Utility Vehicle |
| Language | English |
Essential safety precautions and practices to follow during maintenance and repair work.
Introduction to the fault finding section, emphasizing safety and systematic diagnosis.
Identifies causes and remedies for engine starting issues when no exhaust smoke is present.
Identifies causes and remedies for engine starting issues when exhaust smoke is present.
Diagnoses causes for engine failure to crank or slow cranking speed.
Troubleshooting guide for engine issues where the engine starts but then stops.
Identifies causes for poor engine running conditions.
Diagnoses specific causes for poor engine performance when running at idle.
Troubleshooting guide for identifying sources of excessive engine noise.
Identifies causes for engine knocking sounds related to compression issues.
Diagnoses reasons for reduced engine power and performance.
Troubleshooting steps for when the engine fails to reach its maximum operating RPM.
Identifies causes for fluctuations or surges in the engine's RPM.
Diagnoses causes of excessive vibration originating from the engine.
Troubleshooting guide for excessive black smoke emitted from the engine exhaust.
Troubleshooting guide for excessive white or blue smoke emitted from the engine exhaust.
Diagnoses reasons why the engine fails to shut down properly.
Identifies causes for excessive fuel consumption by the engine.
Troubleshooting guide for fuel or oil leaks originating from the exhaust manifold.
Diagnoses causes for excessive lubricating oil consumption by the engine.
Identifies reasons for lubricating oil contamination and potential causes.
Troubleshooting guide for low lubricating oil pressure issues.
Diagnoses causes for high lubricating oil pressure.
Identifies causes for coolant loss from the system.
To Next Page
