AE- 1 5 0 s y s t e m – U s e r M a n u a l
32
Battery
Battery replacement
When the battery life is getting to its end, the instrument autonomy may
be reduced. Contact ndb Technologies to return your AE-150 instrument to
the factory for battery replacement.
Replacing the battery yourself represents a risk of damage to the
instrument, a risk of injury and will void warranty. ndb
Technologies strongly recommends returning the AE-150
instrument to its factory for battery replacement.
Charging the batteries
Install the proper plug adapter to the charger. Connect the charger to wall
socket (100VAC to 240VAC 50-60Hz). See next figure.
Connect the charger’s connector to the AE-150 main module’s charger port.
Make sure to respect the connector polarity. The charge time is approximately 3
hours for a full charge. Refer to next figure.
To Next Page
Loading...