NEC Baseline Pro CLI User Manual

BaseLine Pro with CLI
6
To re-dial the last number
called
Lift the handset or press
Press
To disable the microphone in
the handset (Mute)
Press
Whatever you say now cannot be heard
by the other party. The LED indicator by
the symbol is lit when the mute function is
on.
The button has a toggle action,
pressing the button again restores the
microphone in the handset or handsfree.
Note: You can also disable the handset
microphone by pressing the pushbutton
on the handset itself.
The status of the button (on or off)
continues if you change the speaking
mode. When the line is released the Mute
function is turned off.
To check the duration of a
call
When you have finished dialling, press
Elapsed time will count up on the display.
If you forget to start the timer it will begin
automatically 6 seconds after the last digit
is dialled.
At the end of a call, the display shows the
call duration for a few seconds after the
end of the call.
To adjust the loudspeaker
volume
Move the slider you will find on the right
side of the phone, under the symbol
To check for messages
Check the indicator beneath the symbol
If lit, a message is waiting for you
To disable ringer
In order to mute the ringer press
for 3 seconds, the display will show
“UNCALL 00~30”.
Pressing adds 30 minutes to the
setting (max 23 hours 30 mins).
Whilst set ring and alarm are silenced.
The setting is cancelled at end of timer or
by going off-hook.

NEC Baseline Pro CLI Specifications

General

Brand	NEC
Model	Baseline Pro CLI
Category	Telephone
Language	English