BaseLine Pro with CLI
7
Phone Book
In on-hook mode, press , LCD
displays “EDIT SEARCH”, press to
enter to edit; press to enter to
search.
Pressing or going off-hook exits phone
book.
BOOK EDIT
Press + to enter to book editting
mode. LCD displays “INPUT NAME”.
Input name by pressing keys “2~9” to
select the required character, “0” = blank;
When the required character is blinking,
press “0” to confirm and input next
character.
When complete press to confirm.
(If no name has been input, press to
input number, this will be a number in
book without name during book search).
LCD displays “INPUT NUMBER”, input
the number and press to confirm and
move to next book entry.
Press or to move the cursor
left or right in book edit mode, insert
character or digit. Press to
backspace, if the cursor is on the left of
the character, press to erase the
character on the right of cursor.
If the book is full (12 entries), LCD
displays “MEMORY FULL”, and no further
entries can be made.
SAVE INCOMING CALL TO BOOK
Search the incoming call number required
to save, when located, press key.
LCD displays “INPUT ADDR”.
Press key.
LCD displays number and name.
Press to confirm the name, and press
again to confirm number;
If the incoming call number does not
contain name, LCD displays number and
“INPUT NAME”, press to skip name,
press again to confirm number and
move to next book entry.
SEARCH BOOK
Press + to enter book search.
Press or to search up or
down;
In searching mode, enter the initial
character to search book;
Press “0” to search the last saved
number without name,
press Press or to search up
or down.
DELETE OR EDIT BOOK ENTRY
In search book mode, find the entry to be
erased or edited:
to erase press twice, LCD displays
“DEL ONE” and entry is erased;
or, press to edit the entry, name can
be edited first and then number.
DIAL FROM BOOK
In search book mode, locate the required
entry, press to dial the number.
To Next Page
Loading...
Need help?
General