NEC Baseline Pro CLI User Manual

BaseLine Pro with CLI
8
Installation settings
During installation settings can be made
to adjust the language, LCD Contrast,
time and date, Local code, Long Prefix,
Ext. Prefix, Alarm, Ring Melody, Flash
Time, Pause Time, Dialling Mode and
Parallel setting.
In on-hook mode, press “SET/HOLD” key
to enter settings mode, the LCD will
display the selections. Pressing the “UP”
or “DOWN” key scrolls through the items
and pressing “SET/HOLD” key again
confirms the selection and enter the next
available setting. The settings mode can
be exited at any time by pressing the
“DELETE/TIME” key to, or by not
selecting any key for 30 seconds.
The settings menu is as follows:
Language
English, Francais, Espanol,
Portugues, Polish, Italiano,
Svenska, Deutsch, Nederlands,
Turkce
LCD Contrast
1 to 7 (3 = default)
Date/Time
Local Code
Enter up to 5 digits(0~9)
Long Prefix
Enter up to 5 digits (0~9)
Ext. Prefix
Enter up to 3 digits (0~9, P)
Alarm
Up to 3 alarms can be set (if
USB power not connected no
beep is output)
Ring Melody
01~17 (if USB power not
connected only 1~4 is available)
Flash
100/270/300/600/1000mS
Pause
1/2/3/4 seconds
Tone/Pulse
Tone/Pulse dialling
Parallel
Allow/Forbid parallel telephoen
from dialling.
Additional settings can be made
by selecting the switches
situated beneath the memory
label.
These switches define Message
waiting type and recall type,
they can be set as:
Message Waiting:
Reverse Polarity/
High Voltage/Off
Recall type:
Earth recall or Timed
Break Recall

NEC Baseline Pro CLI Specifications

General

Brand	NEC
Model	Baseline Pro CLI
Category	Telephone
Language	English