English-18
Battery Installation and Replacement
The remote control is powered by two 1�5V AAA batteries� To install or
replace batteries:
1� Open the battery cover of the remote
control by pushing and pulling it in
the direction of the arrow�
2� Insert two new “AAA” size batteries
for the remote control� When
replacing old batteries, push them
towards the springs and lift them out�
3� Match the batteries to the (+) and (-)
marks in the battery compartment�
4� Insert the bottom of the battery, the
(-) side, into the battery compartment
rst, push towards the springs and
insert the top of the battery, the (+)
side, into place� Do not force the
battery into the battery compartment�
5� Close the battery cover making sure
the tabs rest in the corresponding
holes and push down the cover until
it clicks shut�
Connect To The Power Source
The TV should be installed close to an easily accessible power outlet� Fully
insert the prongs into the power outlet socket� A loose connection may cause
image degradation�
If there is power to the TV, the front LED at the bottom of the TV will be either
none or red� A red LED means the TV is in standby mode�
To Next Page
Loading...
