NEC GT210 - Making Calls Using IP Addresses

FW version 1.0.4.152
17
 Via Paging/Intercom.
1. Take handset off hook; or
Press SPEAKER key; or
Press HEADSET key with headset plugged in; or
Press an available LINE key to activate speaker.
2. You shall hear dial tone after off hook.
3. Press MENU key to switch the call screen from "Dialing" to "Paging".
4. Enter the number.
5. Press SEND key or # to dial out.
 Via Intercom Hard Button. Dial pre-configured intercom number.
1. Go to phone’s Web GUISettingsCall Features, configure the Intercom User ID as the
destination number of intercom call.
2. When phone is idle, press the in Intercom Hard Button to dial pre-configured number.
Notes:
 After entering the number, the phone waits for the No Key Entry Timeout (Default timeout is 4
seconds, configurable via Web GUI) before dialing out. Press SEND or # key to override the No
Key Entry Timeout.
 If digits have been entered after handset is off hook, the SEND key will work as SEND instead
of REDIAL.
 By default, # can be used as SEND key to dial the number out. Users can disable it by setting
"Use # as Dial Key" to "No" from Web GUIAccountsAccount 1Call Settings.
 For Paging/Intercom, if the SIP Server/PBX supports the feature and has Paging/Intercom
feature code set up already, users do not necessarily need toggle to paging mode in the call
screen. Simply dial the feature code with extension as a normal call.
Making Calls Using IP Addresses
Direct IP Call allows two phones to talk to each other in an ad-hoc fashion without a SIP proxy. VoIP
calls can be made between two phones if:
 Both phones have public IP addresses; or
 Both phones are on the same LAN/VPN using private or public IP addresses; or
 Both phones can be connected through a router using public or private IP addresses (with
necessary port forwarding or DMZ).
To make a direct IP call, please follow the steps below:
1. Press MENU key to bring up main menu.
2. Select "Direct IP Call" using the navigation arrow keys.
3. Press MENU to enter the Direct IP Call mode.
4. Input the 12-digit target IP address (Please see example below).