NEC M282X - Projecting images stored in a USB memory device

74
4. Using the Viewer
❷ Projecting images stored in a USB memory device
ThissectionexplainsthebasicoperationoftheViewer.
TheexplanationprovidestheoperationalprocedurewhentheViewertoolbar(→page78)issettothefactoryde-
fault.
•StartingtheViewer .......................................................................below
•RemovingtheUSBmemoryfromtheprojector ....................... page76
•ExitingtheViewer .................................................................... page76
Preparation:BeforestartingtheViewer,storeimagestotheUSBmemoryusingyourcomputer.
Starting the Viewer
1. Turn on the projector. (→page17)
2. InserttheUSBmemoryintotheUSB-Aportofthepro-
jector.
• DonotremovetheUSBmemoryfromtheprojectorwhile
it’s LED flashes. Doing so may corrupt the data.
3. PresstheSOURCEbuttonontheprojectorcabinet.
The Viewer start screen will be displayed.
• PresstheUSB-Abuttonontheremotecontrol.