1. Preparing User Supportware 3
14
7
In the "Ready to Install the Program" screen, click [Install].
The installation will begin.
Important
• Immediately after installation has been started, the following screen may be displayed.
For Windows XP For Windows 2000
Click Click
If the above screen is displayed, click [Continue Anyway] when Windows XP is used.
Click [Yes] when Windows 2000 is used.
NEC has confirmed that the driver of this software correctly runs on Windows XP and
Windows 2000.
• When you install the driver, the personal computer screen will go blank momentarily.
When installation has been completed, the "InstallShield Wizard Completed" screen is displayed.
8
Click [Finish].
A message prompting you to restart the system will be occasionally displayed.
When the desktop screen of Windows is displayed, click [Start] → [Run...] → [CD-ROM drive name +
SETUP.EXE (e.g., Q\:SETUP.EXE)], followed by [OK]. The menu screen of the User Supportware 3
CD-ROM will be displayed again.
9
When the message prompting you to restart the system is displayed, click
[Yes].
Windows will be restarted.
To Next Page
Loading...
