1
1. Preparing User Supportware 3
15
Preparing User Supportware 3
● Installing Desktop Control Utility 1.0
1
Click [Installing Desktop Control Utility 1.0] in the menu screen.
Preparation for the installation will begin.
When preparation is complete, "Welcome to the InstallShield Wizard for Desktop Control Utility 1.0"
screen is displayed.
• The procedure is the same as that of Image Express Utility 2.0 ( page 13).
• Desktop Control Utility 1.0 does not have a screen for selecting "Typical" or "Extension".
• After completion of the installation, if a message prompting you to restart the system is displayed,
click [Yes].
• When the desktop screen of Windows is displayed, redisplay the menu screen of the User
Supportware 3 CD-ROM.
● Installing Ulead Photo Explorer 8.0
Important
••
••
• Be sure to register your software.
Technical support for Ulead Photo Explorer 8.0 is provided to registered users only.
Note that user registration for Ulead Photo Explorer 8.0 included on the User Supportware
3 CD-ROM is possible only via the registration site that is displayed during the installation
of the software. Be sure to connect your personal computer to Internet when installing
Ulead Photo Explorer 8.0.
••
••
• About the software license
Ulead Photo Explorer 8.0 in the User Supportware 3 CD-ROM may only be used on a
single personal computer.
If you need to install Ulead Photo Explorer 8.0 onto multiple personal computers, purchase
an additional User Supportware 3 CD-ROM for each additional personal computer you
wish to install Ulead Photo Explorer 8.0 onto.
1
Click [Installing Ulead Photo Explorer 8.0] on the menu screen.
Ulead Photo Explorer 8.0's setup screen will be displayed.
To Next Page
Loading...
