W A R N I N G
The SERVICE PERSONNEL should have the appropriate technical training knowl-
edge and experience necessary to :
Be familiar with specialized test equipment, and
Be careful to follow all safety procedures associated with high voltage CRT
circuit designs to minimize danger to themselves and their coworkers.
To avoid electrical chocks, this equipment should be used with an appropriate
power cord and be connected only to a properly grounded AC outlet
This equipment utilized a micro-gap power switch. Turn off the monitor by first
pushing the front panel power switch. Next, remove the power cord from the AC
outlet.
To prevent fire or shock hazards, do not expose this unit to rain or moisture
This symbol warns the personnel that un-insulated voltage within the unit
may have sufficient magnitude to cause electric shock.
This symbol alerts the personnel that important literature concerning the
operation and maintenance of this unit has been included.
Therefore, it should be read carefully in order to avoid any problems.
PRODUCT SAFETY CAUTION
1. When parts replacement is required for servicing, always use the manufacturer’s specified
replacement.
2. Comply with all caution and safety-related notes on the product display chassis and picture tube.
3. When replacing the component, always be certain that all the components are put back in the
place.
4. When servicing display monitor unit, it is required that the provided lead dress is used in the high
voltage circuit area.
5. It is also recommended that shatter proof goggles are worn, when removing, installing and han-
dling the picture tube. People not equipped with the proper precautionary measures mentioned
should keep the picture tube away from body while handling.
6. As for a connector, pick and extract housing with fingers properly since a disconnection and
improper contacts may occur, when wires of the connector are led.
7. Use a proper screwdriver. If you use screwdriver that does not fit, you may damage the screws.
To Next Page
Loading...
Need help?
General