NEC NP-P350W - Clearing Lamp and Filter Usage Hours

145
7. Maintenance
7. Putthelterunitbacktotheprojectorcabinet.
 Makesurethatthelterunitisplacedinthecorrectorienta-
tion.
8. Puttheltercoverbacktotheprojectorcabinet.
Insert two catches of the top side of the filter cover into the
groove of the cabinet, and push the buttons on the left and right
to close the filter cover.
• Pushtheltercoveruntilitclicksintoplace.
9. Clearthelterusagehours.
Plug the power cord into the wall outlet, and then turn on the
projector.
From the menu, select [RESET] → [CLEAR FILTER HOURS].
(→ page 104)
The interval time to clean the filters is set to [OFF] at time of
shipment. When using the projector as it is, you do not clear
the filter usage