NEC NP200 - Powering On the Projector

Powering On/Off the Projector
Powering On the Projector
.
2.
3.
.
Ensure that the power cable and signal cabte are securely
connected. The Power LED witt flash blue.
Remove the tens cap. @
Turn on the tamp by pressing "Power" on the control panel.
O The startup screen (NEC logo) will display and the Power
LED will turn blue.
Turn on your source (computer, notebook, video player, etc.)
The projector witt detect your source automatically.
If you connect multiple sources at the same time, use the
"Source" on the remote control or use "Computer", "S-Vid-
eo", "Video" on the remote control to switch inputs.
Turn on the projector
first and then the signal
sources_
POWER
Lens Cap Power
THE TRUSTED SOURCE FOR PROJECTOR LAMPS AND ACCESSORIES