NEC P350W - Correcting Keystone Distortion Manually; Adjusting with Buttons on the Cabinet

22
2. Projecting an Image (Basic Operation)
 Correcting Keystone Distortion Manually
Ifthescreenistiltedvertically,keystonedistortionbecomeslarge.Tocorrectkeystonedistortionmanually,proceed
withthefollowingstepstocorrectkeystonedistortion.
NOTE:
• Themaximumrangeofverticalkeystonecorrectionis+/−30degrees.
• TheKeystonecorrectioncancauseanimagetobeslightlyblurredbecausethecorrectionismadeelectronically.
• TheKeystonecorrectionrangecanbemadenarrower,dependingonasignaloritsaspectratioselection.
Adjusting with buttons on the cabinet
1. Pressthe or buttonwithnomenusdisplayed.
 Thekeystonebarwillbedisplayed.
2. Usethe or tocorrectthekeystonedistortion.
3. PresstheENTERbutton.
 Thekeystonebarwillbeclosed.
NOTE:
• Whenthemenuisdisplayed,theaboveoperationisnotavailable.Whenthemenuisdisplayed,presstheMENUbuttontoclose
themenuandstarttheKeystonecorrection.
 Fromthemenu,select[SETUP]→[GENERAL]→[KEYSTONE].Thechangescanbesavedwith[KEYSTONESAVE].(→page
91)
• KeystonecontrolisnotavailablewiththeorbuttonwhenVIEWERorNETWORKisused.