NEC P502WL-2 - 7 Network Settings; Projector Name; Network Information; Wired Lan

22
7. NETWORK SETTINGS
CongurationforconnectingthisdevicetoawiredLANorwirelessLAN.
7-1. PROJECTOR NAME
Set the projector name and host name. The default factory setting is the manufacturing number of this device.
Item Description Remarks
Projector name Set up the projector name A maximum of 16 alphanumeric
characters
Host name Set the host name of this device. A maximum of 16 alphanumeric
characters
7-2. NETWORK INFORMATION
Displaytheinformationwhenthisdeviceisconnectedtoanetwork(wiredLAN/wirelessLAN).
7-3. WIRED LAN
CongurethesettingsforconnectingthisdevicetoawiredLAN.
Item Description Remarks
Profile
ThesettingswhenconnectingthisdevicetoawiredLANcan
be registered in 2 ways (Profile 1 and Profile 2).
DHCP/IPADDRESS/
SUB NETMASK/
GATEWAY/AUTO-
MATICDNS
Performrequiredsettings
Reconnection Try connecting to the network again. Reconnect after chang-
ing the settings.
NOTE:
• IfyoucannotobtainIPaddressbydisconnecting/connectingtheLANcableunderthestatetheDHCPhasbeenset,poweroffthis
device once and then power it on again.
7-4. Wireless LAN
CongurethesettingsforconnectingthisdevicetoawirelessLAN.
Item Description Remarks
Profile Select the configuration name when connecting this device
toawirelessLAN.
• Disable:Noradiowaveswillbetransmittedfromthewire-
lessLANunitconnectedtothisdevice.
• INTELLIGENTCONNECTION
This function enables connection to the projector using the
MultiPresenter application by inputting a PIN code (4-digit
number).
• Simpleaccesspoint:Connecttoacomputerorsmartphone
by setting this device as a simple access point.
• Wi-Fi Direct: Connect to adevice compatible withWi-Fi
Direct.
• Miracast:ConnecttoadevicecompatiblewithMiracast
• Prole1/Prole2:ThewirelessLANsettingscanbereg-
istered in 2 ways.
• Thedefaultfactorysetting
whenshippedis“Disable”.
• Ifasimpleaccesspoint
has been set up, the IP
address of this device
willbe“192.168.120.1”or
“192.168.130.1”.
NOTE: When a simple access
pointissetup.Upto20unitscan
beconnectedsimultaneously.
Recommend to connect approx.
10unitsfornormaloperation.
DHCP/IP address/
Subnet mask/Gate-
way/DNS
These can be set when Profile 1 or Profile 2 is selected.
Advanced settings The configuration items differ for each profile option. Refer
to the following table.
Reconnection Try connecting to the network again. Reconnect after chang-
ing the settings.