NEC PA723U - Page 21

7
1. Introduction
Filter cover
Preparation:Removetheltercoverfromtheprojector.
Refertotheclause“Replacingthelter”onpage160abouttheltercoverinstallation.
1. Insert the round protrusion at the filter cover strap end (resinoid strap) to the hole on the filter cover.
2. Insert the square protrusion at the opposite end of the filter cover strap to the hole on the projector body
and rotate the strap 90°for fixation. It becomes easier to fix the strap if you remove the filter once.
Hole for xing the strap
Rotate the strap 90°
How to paste the input selection character sticker of the remote control
• PeeloffthecoverofthestickerandalignthestickerholeswithButtons1to6beforepasting.
• Pleasetakecarenottoletthestickercontactthebuttonswhenpasting.
• Theexplanationsandillustrationsinthismanualareprovidedwiththestickerpasted.