To Next Page

To Previous Page

130

5. Using On-Screen Menu

[SOURCE OPTIONS]

SettingAutoAdjust[AUTOADJUST]

ThisfeaturesetstheAutoAdjustmodesothatthecomputersignalcanbeautomaticallyormanuallyadjustedfor

noiseandstability.Youcanautomaticallymakeadjustmentintwoways:[NORMAL]and[FINE].

OFF �� The computer signal will not be automatically adjusted� You can manually optimize the computer signal�

NORMAL �� Default setting� The computer signal will be automatically adjusted� Normally select this option�

FINE �� Select this option if ﬁne adjustment is needed� It takes more time to switch to the source than when [NOR-

MAL]is selected�

TIP:

• Thedefaultsettingwhenshippedfromthefactoryis[NORMAL].

• WhentheAUTOADJ.buttonispressed,thesame[FINE]adjustmentiscarriedout.

[AUDIO SELECT]

ThisselectstheaudioinputoftheHDMI1INterminal,HDMI2INterminal,DisplayPortinputterminalandHDBaseT

IN/Ethernetport.

Selecting Default Source [DEFAULT INPUT SELECT]

Youcansettheprojectortodefaulttoanyoneofitsinputseachtimetheprojectoristurnedon.

LAST �� Sets the projector to default to the previous or last active input each time the projector is turned on�

AUTO �� Searches for an active source in order of HDMI1 → HDMI2 → DisplayPort → COMPUTER → HDBaseT and

displays the ﬁrst found source�

HDMI1 �� Displays the digital source from the HDMI 1 IN connector every time the projector is turned on�

HDMI2 �� Displays the digital source from the HDMI 2 IN connector every time the projector is turned on�

DisplayPort �� Displays the digital source from the DisplayPort every time the projector is turned on�

COMPUTER �� Displays the computer signal from the COMPUTER IN connector every time the projector is turned on�

HDBaseT �� Project the HDBaseT signal�

[SEAMLESS SWITCHING]

Whentheinputconnectorisswitched,theimagedisplayedbeforeswitchingisheldtoswitchtothenewimagewithout

abreakduetoabsenceofasignal.

Selecting a Color or Logo for Background [BACKGROUND]

Usethisfeaturetodisplayablue/blackscreenorlogowhennosignalisavailable.Thedefaultbackgroundis[BLUE].

NOTE:

• Evenwhenthebackgroundlogoisselected,iftwopicturesaredisplayedin[PIP/PICTUREBYPICTURE]mode,thebluebackground

is displayed without the logo when there is no signal.

NEC PA723U User Manual

Other manuals for NEC PA723U