NEC Display Solutions of America, Inc.
PX1005QL Installation Guide
Desktop and Ceiling Mount Rev 1.2
www.necdisplay.com PX1005QL Page 1 of 12
Contents
Product Description, Lens Specs, Screen/Aspect Ratio
Notes Pg 1
Distance Charts and Formulas Pg 2-3
Ceiling Mount/Desktop Installation Pg 4
Lens Shift Adjustable Range Pg 5
Cabinet Dimensions Pg 6
Cabinet Dimensions Pg 7
Optional Lens Dimensions Pg 8
Ventilation Requirements/Portrait Requirements Pg 9
Regulatory Labels Pg 10
Input Panel and Button Panel Pg 11
Control Codes Pg 12
Product Description
Type: 1 chip DMD Reflection Type Dimensions: 19.7” (W) x 8.49” (H) x 23.0” (D)
0.66 in. TRP DMD Weight: 68.8 lbs. / 31.2kg
DMD Resolution: 2716 x 1528 (16:9) WQXGA Brightness: 10,000 Lumens
Output Resolution: 3840 x 2160 (16:9) UHD
Fan Noise: 42 dB / 39dB @ 1 meter
Power Consumption: 1222W (max) BTU’s: 4166 BTU/hour
Network Ready, RJ45
Powered: Lens Shift, Horizontal & Vertical /Zoom/ Focus
Lens Specifications
NP39ML-4K: Throw Ratio: ~ 0.38:1 Focal Length: 11.4mm NP19ZL-4K: Throw Ratio: 2.20 -3.67:1 Focal Length: 32.9 – 54.2mm
Screen Sizes: 85”-350” F/#: 1.85 Screen Sizes: 50-300” F/#: 1.86 – 2.48
NP16FL-4K: Throw Ratio: ~ 0.76:1 Focal Length: 11.6mm NP20ZL-4K: Throw Ratio: 3.54 – 5.36:1 Focal Length: 52.8 – 79.1mm
Screen Sizes: 50”-300” F/#: 1.85 Screen Sizes: 50-300” F/#: 1.85-2.41
NP17ZL-4K: Throw Ratio: 1.24 - 1.78:1 Focal Length: 18.7 – 26.5mm NP21ZL-4K: Throw Ratio: 5.25 – 8.28:1 Focal Length: 78.5 -121.9mm
Screen Sizes: 50”-300” F/#: 1.85 Screen Sizes: 50-300” F/#: 1.85-2.48
NP18ZL-4K: Throw Ratio: 1.71 – 2.25:1 Focal Length: 26.0 – 34.0mm NP31ZL-4K: Throw Ratio: 0.74 – 0.93:1 Focal Length: 11.3 -14.1mm
Screen Sizes: 50-300” F/#: 1.70-1.90 Screen Sizes: 50-300” F/#: 1.96-2.3
Screen/Aspect Ratio
4:3, 16:9 and 16:10 screens are fully supported with proper aspect ratio control for both type sources using NEC developed scaling
technology. Menu selections have settings for each screen type and aspect ratio control for each source type.
Notes
For screen sizes not indicated on the projection tables, use the formulas below.
If the figures on the tables do not match the results of formulas, use the figures in the table.
Distances are in inches, for millimeters multiply by 25.4.
Distances may vary 5%.
To Next Page
Need help?
General
