INSTALLATION PROCEDURE
24
5.
Insert the line cord plug (included with the
telephone set) into the modular connector.
6.
Insert the line cord plug into the LINE connector
on the back of the telephone. Wrap the excess
cord and secure it with a tie wrap.
7.
Fit the coiled cord through the groove on the
back of the telephone as shown in the figure
below.
8.
Insert the four tabs on WM-L UNIT in the tab slots
on the back of the telephone.
9.
Tuck the excess cord into WM-L UNIT.
To Next Page
Loading...
Need help?
General