NEC UNIVERGE ITK-12D-1 - Page 33

TERMINAL SETUP
33
TO SET TIME FORMAT
The procedure below shows how to set time display with a 12-
hour or 24-hour clock format.
1. Press Menu key while terminal is in an idle state.
2. Select
□
1 User Settings.
3. Select
□
3 Display.
4. Select
□
1 Calendar Format.
5. Select
□
2 Time Format.
6. Select desired setting from the following list.
No.
Menu Item
Meaning
0
Automatic
Follows the setting on the
system (default)
1
12 hour Indication
12-hour clock
2
24 hour Indication
24-hour clock
■When selecting Automatic or not performing this time
format setting, 12-hour clock is automatically applied.
■Default setting is Automatic.
■The enabled item is highlighted.
TO ENABLE/DISABLE VOLUME GAUGE
The procedure below shows how to display the volume levels:
handset receiver volume, speaker volume, ringer tone volume
and LCD contrast.
1. Press Menu key while terminal is in an idle state.
2. Select
□
1 User Settings.
3. Select
□
3 Display.
4. Select
□
2 Local Volume.
5. Select desired setting from the following list.
No.
Menu Item
Meaning
0
Automatic
Each volume gauge is displayed on
LCD (default).
1
Disable
Each volume gauge is not displayed on
LCD.
2
Enable
Each volume gauge is displayed on
LCD.
The enabled item is highlighted.