TERMINAL SETUP
35
TO SET A LANGUAGE
The procedure below shows how to set a language to be
displayed on LCD.
1.
Press Menu key while terminal is in an idle state.
2.
Select
□
1 User Settings.
3.
Select
□
3 Display.
4.
Select
□
5 Language.
5.
Select a desired language.
For example, press [1] + [3] to select
□
13 English.
The enabled item is highlighted.
Each item is displayed in its native language as follows:
6.
After the selection is completed, press Enter key
or the OK soft key.
TO ENABLE/DISABLE BACKLIGHT
FADE CONTROL
The procedure below shows how to enable/disable the backlight
fade control.
The backlight fades in or fades out when this setting is enabled.
1.
Press Menu key while terminal is in an idle state.
2.
Select
□
1 User Settings.
3.
Select
□
3 Display.
4.
Select
□
6 Advanced.
5.
Select
□
1 Backlight Fade Control.
6.
Select desired setting from the following list.
Backlight fade control of LCD is
disabled.
Backlight fade control of LCD is
enabled (default).
The enabled item is highlighted.
To Next Page
Loading...
