NEC UNIVERGE SV8100 DT7 SERIES - Advanced Call Management; Call Transfer and Conference Calls; Call Parking and Retrieval; Busy;No Answer Callbacks

7
Call Transfer using programmed DSS keys
With a call in progress:
1. Press the Transfer key.
2. Press the programmed DSS button.
3. Announce the call (optional).
4. Replace the handset.
Note 3: A Programmable Function Key may be assigned for DSS.
CONFERENCE
1. Establish intercom or trunk call.
2. Press Conf or Conference key.
3. Dial the extension you want to add. - OR -
Access outside call by dialing 9.
Note: To get the outside call, you can either press a line key or dial a trunk/trunk
group access code.
4. When called party answers, press Conference key twice.
Note: If you cannot add additional parties to your Conference, you have exceeded the
system’s Conference limit.
5. Repeat steps 2~4 to add more parties.
12
CALL PARK - SYSTEM
To Park a call in a system orbit: Note: You can Park Intercom or trunk calls.
1. Press the Park key (Service Code 852: *04 + orbit). Note: The Park key LED lights.
2. Use Paging to announce call.
3. Press Speaker to hang up. Note: If not picked up, the call will recall to you.
- OR -
1. Press the Transfer key.
2. Dial 831 and the Park orbit (01~64). Note: If you hear busy tone, the orbit is busy.
Try another orbit.
3. Use Paging to announce call.
4. Press Speaker to hang up. Note: If not picked up, the call will recall to you.
To pick up a parked call:
1. Lift the handset.
2. Press the Park key (Service Code 852: *04 + orbit). - OR -
1. Press the Speaker key.
2. Dial 861 and the Park orbit (01~64).
13
STATION BUSY/NO ANSWER OPTIONS
Callback Call Busy or unanswered? To place a Callback:
1. Dial 850
2. Hang up.
3. Lift the handset when the busy extension calls you back.