!
!
m Secondary SIP server for failover not supported.
m Network-based call forward, call transfer, sequential ringing, and
simultaneous ringing not supported.
m The interop tested was completed with Registration SIP Trunks, and SIP
Profile 1.
SECTION 2 NEC PBX CONFIGURATION
This section provides information to NEC’s solution providers and NEC Associates for
configuring an NEC UNIVERGE SV9100 to connect to a IDT/Net2Phone SIP Trunk
service provider, utilizing a DYNAMIC configuration.
2.1 Prerequisites
Before you configure the UNIVERGE SV9100, you must have the following
information available.
2.1.1
SIP Trunking Information from IDT/Net2Phone
r
Primary SIP Proxy Server IP Address.
r
Number Plan, if applicable for the Point-to-Point Connection.
r
Trunking DID(s)
The DID(s) are forwarded to the Public WAN IP address(s),
DNS or DNS SRV records of the PBX.
2.1.2
NEC UNIVERGE SV9100
r
SV9100 CPU firmware Version 06.00.60 or higher
r
GPZ-IPLE
r
Digital, IP and TDM Telephones
r
R1 Version License (0411)
r
System Port License (0300)
r
VoIP Resource License (5301)
r
IP Trunk License (5001)
2.1.3
Installation Worksheet
Use the worksheet to record the information needed for setting up
the SIP Trunking service.
To Next Page
Loading...
