!
!
3.2 GCD-CP10 Network Setup
Values shown are for example purposes only. Your actual IP values will be
determined by your local LAN administrator.
Figure 4 GCD-CP10 Network Setup
10-12-1 : GCD-CP10 Network Setup – IP Address
Set the LAN IP address for the system Ethernet port to 192.168.0.10
10-12-2 : GCD-CP10 Network Setup – Subnet Mask
Set the subnet mask for the system Ethernet port to be different than the subnet
for the IPLE blade.
10-12-3 : CCD-CP10 Network Setup – Default Gateway
Set the default gateway for the IPLE blade.
To Next Page
Loading...
