NEC Univerge SV9300 - INSTALLATION PROCEDURE; ATTACHING HANDSET

CHAPTER 2 MIGRATION PROCEDURE
Migrate the voice data recorded to the Voice Response System (VRS)?
Migrate
When the CPU built-in memory (SRAM) is
specified as a memory for the VRS, load the
voice data saved from the SV8300 CPU
built-in memory onto the SV9300 CPU built-in
memory (flash ROM).
[Required Time: About 5 minutes]
See ‘
Procedure to Load Voice Data from CPU
Built-in Memory (SRAM)’. Page 17
Not to Migrate
When the CF memory is specified as a
memory for the VRS, load the voice data
saved from the SV8300 CF memory onto the
SV9300 CPU built-in memory (flash ROM).
[Required Time: About 25 minutes]
See ‘
Procedure to Load Voice Data from CF
Memory’. Page 18
Assign SV8300 system data that is not migrated to SV9300 during system data conversion.
After completing the system data settings, back up the system data (CMEC Y=6>0: 0).
[Required Time: About 5 minutes]
NOTE: For details of the system data that is not migrated by the System Data Conversion Tool, see (6)
in
‘Migration Conditions’. Page 3
Set SV9300 to on-line mode. [Required Time: About 3 minutes]
[Procedure to set on-line mode]
(1) Set the SENSE switch on the CPU blade to “1”.
Confirm SV9300 system data is migrated correctly. [Required Time: About 60 minutes]
End
C
- 10 -