NEC Univerge SV9300 - Page 21

CHAPTER 2 MIGRATION PROCEDURE
Open SV9300 PCPro and connect to Units 02-04 and the Remote Unit.
[Required Time: About 1 minute/Unit]
Perform the System data memory all clear (CM00>1:CCC) and the SRAM area all clear (CM00>02:CCC)
for the Units 02-04 and the Remote Unit. [Required Time: About 5 minutes/Unit]
Assign the IP address information and the Unit Number for each of the Units 01-04 and Remote Unit.
After completing the system data settings, back up the system data (CMEC Y=6>0: 0).
[Required Time: About 5 minutes/Unit]
NOTE: Assign the IP address and the Unit Number for Unit 01 and own unit as below.
- Maintenance port IP address (CM0B Y=0xx>00)
- Maintenance port subnet mask (CM0B Y=0xx>01)
- Maintenance port default gateway (CM0B Y=0xx>02)
- VoIP port IP address (CM0B Y=1xx>00)
- VoIP port subnet mask (CM0B Y=1xx>01)
- VoIP port default gateway (CM0B Y=1xx>02)
- Unit No. (CM0B Y=000>90)
xx: Unit Number
Is ‘Failover System’ being used?
Used
Assign the Unit Number of Secondary Unit
(CM0B Y=001>141) for each of Unit 02-04
and Remote Unit by using the SV9300 PCPro.
After completing the system data settings,
back up the system data (by executing CMEC
Y=6>0: 0).
[Required Time: About 1 minute/Unit]
Not used
Connect to LAN cable to the SV8300 Units 02-04 and the Remote Unit.
Set the SENSE switch to “2-4” or “0”, and push the RESET switch.
Confirm that the system data has been copied and Units 02-04 operate in a normal mode.
[Required Time: About 10 minutes]
Confirm SV9300 system data is migrated correctly. [Required Time: About 60 minutes]
End
D
- 15 -