Additional Information
This page describes the additional information of this manual.
[Regarding the use of
VoIPDB blade
]
The VoIPDB blade that can be used for SV9300 is as follows.
X:Available -:Not available
VoIPDB blade UNIVERGE SV8300 UNIVERGE SV9300
PZ-64IPLA/PZ-128IPLA X -
PZ-64IPLC-A/PZ-128IPLC-A X X
(For migration)
GPZ-64IPLC-A/GPZ-128IPLC-A X
(For adding blade)
X
(For migration)
GPZ-64IPLD/GPZ-128IPLD - X
NOTE:
When using GPZ-64IPLD/ GPZ-128IPLD (VoIPDB) in the SV9300, the automatic update of
SV9300 VoIPDB Firmware is performed only at the first start-up. Incoming/outgoing call via
VoIPDB is not allowed for about 10 minutes from system start-up until firmware update
completion. When using the VoIPDB except for GPZ-64IPLD/ GPZ-128IPLD, manual update
by PCPro is available.
To Next Page
Loading...
