NEC VE303 - Controlling Projector via Serial Connection

20
English ...
Introduction
Controlling the Projector via the Serial Connection
Using the utility software “PC Control Utility Pro 4” that you
can download from our web site
(http://www.nec-display.com/dl/en/index.html), the projector
can be controlled from a computer via the serial connection.
Control Functions
Power On/Off, signal selection, picture freeze, picture mute,
audio mute, adjusting, error message notication, event
schedule.
Screen of PC Control Utility Pro 4
This section provides an outline of preparation for use of PC Control
Utility Pro 4. For information on how to use PC Control Utility Pro 4,
see Help of PC Control Utility Pro 4.
• Step 1: Install PC Control Utility Pro 4 on the computer. Please see
page 21.
• Step 2: Connect the projector with the computer by a serial cable.
• Step 3: Start PC Control Utility Pro 4. Please see page 22.
TIP:
• For update information on PC Control Utility Pro 4, visit our website:
http://www.nec-display.com/dl/en/index.html
Error notication
function is not
available on this
projector.
(PC Control Utility Pro 4)