26
English ...
Installation
Powering On/Off the Projector
Turn on the
projector rst and then
the signal sources.
POWER/STANDBY
1
When you rst
turn on the projector,
you will get the
Startup menu. This
menu gives you the
opportunity to select
the menu languages.
To select the language,
use the , ,
, or button on the
remote control. Select
your language. Please
see page 48.
While the POWER
LED indicator is
blinking green in short
cycles, the power
cannot be turned off
by using the “POWER
OFF” button.
Powering On the Projector
1. Securely connect the power cord and signal cable. When
connected, the POWER/STANDBY LED will turn Red or
Orange (*).
2. Turn on the projector by pressing the “POWER ON” button
on the remote control or the button on the control panel.
At this moment, the POWER/STANDBY LED will now turn
Green.
The startup screen will display in approximately 10 seconds.
The rst time you use the projector, you will be asked to
select the preferred language and power saving mode.
3. Turn on your source (computer, notebook, video player, etc.)
The projector will detect your source automatically.
If you connect multiple sources at the same time, press the
“SOURCE” button on the control panel or direct source keys
on the remote control to switch between inputs.
To Next Page
Loading...
