NEC VE303 - Powering Off the Projector

27
... English
Installation
Powering Off the Projector
1. Press the “POWER OFF” button on the remote control or the
button on the control panel to turn off the projector lamp,
you will see a message as below on the on-screen display.
ARE YOU SURE ?
YES
NO
POWER OFF
2. Press the “POWER OFF” button again to conrm.
3. Disconnect the power cord from the electrical outlet and the
projector. If you disconnect the power cord while viewing
the picture and connect the power cord again, wait for at
least one second until you connect the power cord again.
While the POWER
LED indicator is
blinking green in
short cycles, the
power cannot be
turned off by using
the “POWER OFF”
button.